Corsair Obsidian 450D Mid-Tower Chassis Review

by - 6 years ago

«»

Exterior


The left side panel is held in place with a pair of thumb screws and features a huge side panel window with a mild tint, giving us a great view of the chassis interior that will look stunning if you have any internal lighting installed.

DSC_3757

The right side panel is a plain black panel and it is also held in place with a pair of quick release thumb screws.

DSC_3758

The front panel certainly looks different to much of the Obsidian range, which often favour a full aluminium panel. There’s the IO panel at the top, two extra wide 5.25″ drive bay covers and the clip-in dust filtered panel that feeds the two 140mm fans; all of which are finished in gorgeous black brushed aluminium.

DSC_3759

The IO panel features the power and HDD LEDS at the top centre with the master power switch between them, then you’ll find HD Audio, reset switch on the left and a pair of USB 3.0 ports on the right.

DSC_3760

The front panel can be released with two push-click buttons in the corners, this allows it to pull forward and be lifted out for maintenance.

DSC_3761

This makes cleaning the dust filter that is build into the frame of the front cover a lot easier, while also making it possible to access the front fan mounts.

DSC_3762

Around the back you’ll notice that there is quite a lot of chassis above the motherboard and fan mounts, this should give us plenty of extra internal space for mounting water cooling radiators in the top of the chassis. There is a pre-installed 120mm fan and below that you’ll find three pop-out metal caps for some extra water / cable routing holes. There are 7 expansion bays in total, each of which features ventilated metal covers that are held in place with thumb screws.

DSC_3764

The top features loads of ventilation space, and a fine dust filter that is held in place by magnets.

DSC_3765

This means you can just lift the cover off quickly to clean it, as well as access the multitude of mounting options on the top of the chassis, you’ll find room for 3 x 120mm / 2 x 140mm fans, and matching radiators.

DSC_3766

The underside features yet another magnetic dust filter that covers the entire base of the chassis.

DSC_3767

It’s easy to remove for cleaning and helps provide clean airflow to your PSU and any base mounted cooling. Dependant on your internal configuration you can get 2 x 120mm / 2 x 140mm or water cooling radiators in the base of the chassis. This obviously means you can have water cooling radiators in the front, back, top and bottom of the chassis!

DSC_3768

Article Index

  1. Introduction
  2. Exterior
  3. Interior
  4. Complete System
  5. Final Thoughts
  6. View All

Author Bio

Add a Comment

Related Posts

0 SHARES

0 SHARES

0 SHARES

0 SHARES

0 SHARES

0 SHARES