Corsair Graphite Series 780T Full Tower Chassis Review

by - 6 years ago



The chassis interior is vast, with everything finished off in a slick black paint job to give it a nice uniformed look. The back plate features a huge cut-out behind the motherboard which will help when mounting or changing a CPU cooler, and there are five large cut-outs with rubber grommets to aid with cable management.


There are two fully removable hard drive bays in the front, each with support for three 3.5″ or 2.5″ drives.


The base of the chassis has a considerable amount of space available, that will hold even the largest consumer PSUs on the market. There is also a large cut-out for routing all of your power cables, space for extra fans and radiators. Large radiators will require you to remove the hard drive bays, although you can still use the dedicated 2.5″ bays, or suspend the 3.5″ bays from the bottom of the 5.25″ bays.


Each of the expansion slots come fitted with a reusable ventilated cover, each held in place with a quick release thumb screw.


The rear 140mm fan has plenty of room above and below it, perfect for AIO water coolers which feature a built in reservoir.


The two 5.25″ drive bays come equipped with a simple tool free locking mechanism.


Around the back you’ll find an extensive space for routing cables, as well as a bunch of cable tie loops to help keep things neat and tidy.


There is a deep recess at the bottom, perfect for tucking away even more cables, and very handy for those who have a non-modular PSU.


There are three dedicated 2.5″ drive bays around the back and a cut-away on the back plate allows you to see the drives displayed from the left side panel window. These bays also completely removable should you need to; something that will no doubt please chassis modders.


Article Index

  1. Introduction
  2. Exterior
  3. Interior
  4. Complete System
  5. Final Thoughts
  6. View All

Author Bio

Add a Comment

2 Comments on Corsair Graphite Series 780T Full Tower Chassis Review

  • Avatar Wayne says:

    It looks like a very nice chassis albeit a little on the expensive side. I’m also not swayed by the inclusion of a fan controller or USB 2.0 ports either. In my opinion they could’ve left these out altogether, shoved in two more USB 3.0 ports and maybe knocked a bit more off the price but hey, people stuffing circa 2006 parts into this 2014 case could find they come in handy.

  • Avatar Matthew Humpherson says:

    Still can’t beat my phanteks enthoo primo that I got for £135 new from Scan. Never seen it that low before or since was a real bargain considering the features and build quality. For the price it looks like they have used way too much plastic on this.

Related Posts